 | | sound design (Re: 2nd RCX AND PNEUMATICS)
|
|
(...) Yes, my two also emit a rather unpleasant high-pitched sound. Personally, I tend to always use gear motors. In the beginning I used a minimotor for steering a robot, but it was very slow and jammed often. I'd say they are better for rotating (...) (25 years ago, 14-Sep-00, to lugnet.robotics)
|
| |
| | My simple pneumatic switch
|
|
Since this topic has come up, I would like to share my simple pneumatic switch design. It's robust, it works great, and it should be fairly obvious from the picture and description provided in the link below how it works. (URL) (25 years ago, 14-Sep-00, to lugnet.robotics)
|
| |
| | Re: 2nd RCX AND PNEUMATICS
|
|
(...) Speaking of rattling, I recently bought the little red servo motor and that blasted thing is *loud*! Is this normal or did I get a bad model with a flaw? (25 years ago, 14-Sep-00, to lugnet.robotics)
|
| |
| | RE: good sets?
|
|
(...) I think it´s running out so get it while you can! ;) The catalogue inside was from 98, in the 2000 catalogue it´s only very small and not featured at all and in the online catalogue I can´t even find it. Now that I´ve assembled it I must say (...) (25 years ago, 14-Sep-00, to lugnet.robotics)
|
| |
| | Converting the (MS)2 from 6 to 10 outputs... Aide?
|
|
I've been thinking of upgrading my (MS)2 Expander from it's current 6 ports to 10 ports. For those of you that aren't familiar with the (MS)2 Expander you can look here: (URL) the (MS)2 gives you two banks of 3 outputs. Each bank is independent and (...) (25 years ago, 14-Sep-00, to lugnet.robotics)
|
