Subject:
|
More description of Re: Multiple Output Gearbox
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 14 Feb 2000 23:04:37 GMT
|
Viewed:
|
846 times
|
| |
|
|
In lugnet.robotics, Arjen Gerstel writes:
> Sounds interesting. If you like, you can email the pictures to me, and I
> will put them on display on my ISP's web server.
>
> Arjen
Thanks! However, there aren't any pictures. I can sketch up something and scan
it and email it to you, if you wish.
The slider assembly is composed of two four-hole links and three one-hole, two-
bump beams. It assembles with short axles and stoppers to hold it together.
The beams and axles go through the middle two holes of the links in this
order: beam, link, beam, link. Put an idler gear in one end of the links, held
by a long axle. Another long axle goes through the other end hole of the
links, and the slider slides on these two axles. A straight rack gear goes
across the three short beams for the screw to drive it.
Regards, Dave Paule
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Multiple Output Gearbox
|
| Sounds interesting. If you like, you can email the pictures to me, and I will put them on display on my ISP's web server. Arjen "David Paule" <dpaule@diac.com> wrote in message news:Fpw0Ay.1u9@lugnet.com... (...) shafts, (...) output at (...) for (...) (25 years ago, 14-Feb-00, to lugnet.robotics)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
