Subject:
|
Re: Interfacing with a Compass
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 14 Feb 2000 20:18:05 GMT
|
Viewed:
|
823 times
|
| |
|
|
In lugnet.robotics, Andy Stannard writes:
> Hi,
>
> As part of a project a group of us are looking to interface an RCX with an
> electronic compass. Searching on the web has led to us looking at the
> Dinsmore compasses (digital and analogue) and the Precision Navigation 2X
> range of compasses.
>
> Has anyone had any experience with interfacing either of these with an RCX?
> Any ideas, tips, schematics, disaster stories e.t.c would be much
> appreciated.
I have a small board that will do this, but it is all surface mount, so not a
'project' for anybosy who is not experienced with this type of construction...
(1.1inches square - drives as a 'standard' light sensor).
Best Wishes
|
|
Message has 1 Reply:
 | | Re: Interfacing with a Compass
|
| (...) an (...) RCX? (...) not a (...) construction... (...) Roger, would you share the schematics of your interface with us? Mario Web page: (URL) member page: (URL) member of ItLUG: (URL) (25 years ago, 15-Feb-00, to lugnet.robotics)
|
Message is in Reply To:
| | Interfacing with a Compass
|
| Hi, As part of a project a group of us are looking to interface an RCX with an electronic compass. Searching on the web has led to us looking at the Dinsmore compasses (digital and analogue) and the Precision Navigation 2X range of compasses. Has (...) (25 years ago, 14-Feb-00, to lugnet.robotics)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
