Subject:
|
Re: Controlling pneumatics II [fischertechnik valves]
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 8 Feb 2000 02:32:58 GMT
|
Viewed:
|
1887 times
|
| |
|
|
"Mihalka, Michael" wrote:
> Folks,
> I finally received my advanced pneumatics set from Dacta and have integrated
> the fishertechnik valves into the sliding door model. Not surprisingly all
> worked well in the initial test which can be seen at:
> http://www.geocities.com/Athens/Column/9278/Pic00018.jpg
> <http://www.geocities.com/Athens/Column/9278/Pic00018.jpg>
> I must say that I was somewhat
Hi, Mike,
Seems your posting got sort of cut off. I'm sure you have more to say.
As it takes up 2 RCX output ports to control one cylinder, you will run out of
output ports for a mobile robot. So that's a point down for the Fischer technik
implementation.
--
C S Soh
http://web.singnet.com.sg/~cssoh
... where air is power
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Controlling pneumatics II [fischertechnik valves]
|
| Folks, I finally received my advanced pneumatics set from Dacta and have integrated the fishertechnik valves into the sliding door model. Not surprisingly all worked well in the initial test which can be seen at: (URL) I must say that I was somewhat (26 years ago, 5-Feb-00, to lugnet.robotics)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
