 | | Re: Making Light Sensor Passive
|
|
I'm not sure what you mean by "making light sensor passive". The light sensor, by design, requires power to work. You can tell the RCX that the light sensor is a passive sensor, but you don't get much range in readings - the phototransistor in the (...) (28 years ago, 25-Feb-99, to lugnet.robotics.rcx.nqc)
|
| |
 | | RE: IR outputB
|
|
So, it seems like the short answer to this question is no one knows what to attach to correctly and safely (to prevent HB damage) allow IR transmissions from the HB :) I understand the receiving capabilities, as they are documented and have routines (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
 | | RE: IR outputB
|
|
I heard that radio waves do not need "line-of-sight" like IR does. Can someone with more exerience verify or dispute this? It makes sense since longer wavelengths of EMR can bounce off surfaces easier. So maybe your Lynx device is better. ---...--- (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
 | | RE: IR outputB
|
|
The software written by Max Davies should allow transmission as well as receiving. The information that I have doesn't include the hardware layout but as far as I understand the 1K resistor in the IR transmission circuit on the board should allow an (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
 | | RE: IR outputB
|
|
I had intended the two types of interfaces for different purposes, but, I assume RF does not need line of site work. R/C cars for example can be controlled from several rooms away in my house (worked with one on a telepresence implementation). I (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
 | | RE: IR outputB
|
|
I am looking at the Schematic in the HB HP right now. It looks like the 1K resistor is connected to the visible LED. From the schematic, it looks like you can connect a resitor and IR LED in series to the "3-pin female header" to make your (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR outputB
|
|
(...) i do not have the Mobile robots inspiration book, but i think if you want to use it in a good way you will have to flash the right led for a time, check for reflection, then switch it of and check if there is also reflection (then it was (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
 | | (no subject)
|
|
Has anyone hacked the sonar out of a sonar tape measure? Radio Shack sells sonar tape measures for about $25.00, that's half the price of buying the transducer and sensor together. I mentioned in a previous posting that I am interested in running (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
 | | IR proximity detector for RCX!
|
|
Hi all, I just finished a little experiment to interface my IR proximity detector to my RCX brick. It works fine. Using this nifty item I can get a left/right/both/neither detection data into the RCX using only the sensor 2 block and the "light" (...) (28 years ago, 25-Feb-99, to lugnet.robotics)
|
| |
 | | RE: IR outputB
|
|
(...) Of course... have you ever listened to your radio in the house before? (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|