To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *9691 (+5)
  Problem resolved?
 
To all, Regarding my previous... I am not sure if it was a soldering connection, but after retesting the output voltages it is very close.. Fred says that the voltages should be between, say, +9 and +10, but I'll get a 8.7.. Is this good enough? If (...) (28 years ago, 24-Feb-99, to lugnet.robotics.handyboard)
 
  Re: Contest
 
Actually, I believe that the original poster suggested that here be a bonus or award for achieving the goal while limiting their entry to only a single RIS. Based on the ideas that have been flowing in, it sounds doable to achieve the result with a (...) (28 years ago, 24-Feb-99, to lugnet.robotics)
 
  Re: Contest: two motor idea
 
Alan Do you have a schematic or diagram of your ideas? What type of gearing would you have to allow two separate gear movements forward and back? Does anybody else have any configurations they've come up with to accomplish the same task? I'm (...) (28 years ago, 24-Feb-99, to lugnet.robotics)
 
  RE: External Motor Power and the Expansion board.
 
I noticed this to when I built mine, I just bridged the gap I had cut with solder and now use an H-bridge to control the motors. Clancy (...) (28 years ago, 24-Feb-99, to lugnet.robotics.handyboard)
 
  Re: Contest Rules
 
I can understand the first part of the rule below, but I thought that the cans where to be placed at random, so which can placement rules are you referring to?. "The robot may have knowlege about the number of cans or about rules of can placement." (...) (28 years ago, 24-Feb-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR