 | | Re: Expansion board questions
|
| Hi Duncan, I would like to have a copy of your hbtest.c to test the expansion board. If you could post it I bet a lot of us would use it to test. Thanks in advance Terry G. ---...--- (...) doesn't (...) which (...) the (...) the (...) height (...) I (...) (28 years ago, 15-Feb-99, to lugnet.robotics.handyboard)
| | |  | | Re: Expansion board questions
|
| (...) Terry, I will send you the code. I sent it to Fred for the website but haven't heard back. I'm reluctant to post it to the list, but I will mail it to anyone who asks... Best, Duncan (28 years ago, 15-Feb-99, to lugnet.robotics.handyboard)
| | |  | | Sensors
|
| I am gathering parts to make sensors and was wondering if anyone has a good source for small microswitches ( for tuch sensors) and also LED lights 9 to 12 volt. Thanks in Advance Jim Clark ---...--- This message was sent from Bess.Net, a filtered (...) (28 years ago, 15-Feb-99, to lugnet.robotics)
| | |  | | Expansion board test routine
|
| Hello all, Well here it is, for what it's worth. The functions are pretty obvious, it works just like the original hbtest.c that Fred wrote. To try servos other than #5, you'll have to edit the line: servo5=(16*knob()); In the test_servo() routine. (...) (28 years ago, 15-Feb-99, to lugnet.robotics.handyboard)
| | |  | | Re: Sensors
|
| I found every thing I needed as far as the light sensors at Radio Shack. I don't know where you're located, but here in California, Fry's Electronics is the place to go. You can get everything you need from parts, boards, and the junk food to eat (...) (28 years ago, 15-Feb-99, to lugnet.robotics)
| |