 | | Re: HB Expansion kit
|
| ---...--- (...) Yes (...) ----6---J2-19 pin ,J19-two 4 pin,J6-4 pin,-one 14 pin for the LCD,-one 4 pin lower r.h. over digital 0,1,2,3. on the hb. All go on the outer edge of the board except J19. Hope this helps, I was also pleased with the kit (...) (28 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
| | |  | | Mindstorm Mac Patch
|
| Has anyone had success using the Mac patches for Mindstorms with an Apple PC compatibility Card? (URL) have a 12" Apple PC Compatibility Card and have tried both patches with no success. I would like to hear from someone who has gotten one to work (...) (28 years ago, 30-Jan-99, to lugnet.robotics)
| | |  | | infrared distance sensor
|
| Hi, I've just received a Sharp Digital Infra-Red Ranging System (GP2D02) and I'd like to connect it to the handyboard. The device clocks the data in on a digitial input but requires the clocking pulses to be no longer than 200 microseconds. This (...) (28 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
| | |  | | Re: HB failure
|
| (...) Thanks for your response. When we load the pcode_hb.s19file with the right CONFIG it seems to load properly. We then turn the HB off and back on and try to load the Interactive C. This does not work at the computer says "attempting to linkt to (...) (28 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
| | |  | | NQC Barcode program
|
| The following is a program someone made on the mindstorms page. There is an error on line 13 but I can't figure it out. I'm not all that experienced so it may be something simple I don't know. Any way, have a look: //This program will decode a "3 of (...) (28 years ago, 30-Jan-99, to lugnet.robotics)
| |