 | | Re: Expansion Board Files
|
|
Fred; Here is the copy of expsens,c---...--- At the lines in the hb was having problems with there was a small square figure at the starting point outside the comment*\ and\* for some reason. Any one else having a problem????? Thanks Terry ---...--- (...) (28 years ago, 26-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | ** voltage dropping and current limitting**
|
|
Hello out there, I have a 24 vdc supply, how can I drop the voltage to about 13 or 14 volts? Would I use resistors across the supply? Or what??? Thanks in advance. -Michael (28 years ago, 26-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: navigation alorithm
|
|
Michael, A few sophomore engineering students here at Penn State Abington have built a micromouse from LEGO and a Handy Board. It has been entered into 2 micromouse contests sponsored by the Phila Chapter of the IEEE. It was quite challenging both (...) (28 years ago, 26-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Thoughts on Turning
|
|
It is a very nice mechanism. But, at least in my implementation, only one motor is pushing your vehicle. Some of my larger bots have needed more power than one seems to crank out. After gearing down further it is painfully slow. I'm currently trying (...) (28 years ago, 26-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Downloading
|
|
yes, there was a linefeed bug in the expsens.c file in hbexplib.zip. it should be fixed now. please re-download from the expansion board software page and try again. let us know if this fixes the problem. thanks a lot. fred In your message you said: (...) (28 years ago, 26-Jan-99, to lugnet.robotics.handyboard)
|