 | | Re: homebrew Temp sensor
|
|
Jasper Janssen wrote in message <36a914e5.172025205@...et.com>... (...) Right, you could use an electrolytic if you wanted to make sure you always plugged your sensor the right way. Many people who are in this group do not know the subtleties of (...) (28 years ago, 23-Jan-99, to lugnet.robotics)
|
| |
 | | Re: The Handyboard (was Re: RCX 2.0 -- ideas.)
|
|
(...) But that would do nothing towards making it truly LEGO electric compatible; coming up with a suitable compartment for the motherboard that leaves room for the expansion board, even if it's not actually connected yet; leaving the display and (...) (28 years ago, 23-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Toy motors
|
|
I tried to use the special RC motor drivers for RC race cars with good luck, they simply connect to a servo output of the handy board and they work great and you can get them in a thousand different configurations like fwd/rev and brakes. They work (...) (28 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | RCX message's
|
|
Hi everybody, I'm new to this newsgroup, and I've found much interesting information on this group. I'm writing a hypercard XFCN to control the Cybermaster and it is working right now, but I have problems with the following messaging commands : 90 (...) (28 years ago, 23-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Flexible axles!!!!
|
|
It is Lego's answer to K'nex. The sets are searchable by there number at Lugnet. try 3552 I think its on the Lego catalog page as well. LINC Chris Stanley wrote in message <36A8FB60.F345807A@usit.net>... (...) (28 years ago, 23-Jan-99, to lugnet.robotics)
|