To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *8306 (+5)
  Re: Flexible axles!!!!
 
what exactly is znap? thanks! -- Chris Stanley cstanley@usit.net (...) (28 years ago, 22-Jan-99, to lugnet.robotics)
 
  Re: RCX 2.0 -- ideas.
 
(...) The big cost in these things, wqould be that you need 5 of the 2*2*2/3 plates at the end of Technic leads, unless you homebrew those too. AFAIK, you can only get leads, at least as far as Service packs are concerned, for about $5-$6 (with 2 (...) (28 years ago, 22-Jan-99, to lugnet.robotics)
 
  Re: expansion ports
 
(...) Reductio ad absurdam: You buy, say, 8880. You lose one of the, say, #12 axles. You replace with 2 #6 and an axle extender. You sell it on (bad move, IMHO, but hey, it could happen :) ). By your reasoning, you now have sold a product, not made (...) (28 years ago, 22-Jan-99, to lugnet.robotics)
 
  Re: Smooth Plates
 
(...) Set 6567 Speed Splasher has two red 1*8 tiles. It is available under $2.50, generally. But don't tell your SO, or you won't be able to buy a few multiples of 8277 :) (just bought two myself, over the last few days... I now have a _really_ (...) (28 years ago, 22-Jan-99, to lugnet.robotics)
 
  Re: Toy motors
 
I was reading the FAQ (again), and unless I overlooked something, it seems that even with the H-bridge or piggybacking solutions, I would not be able to drive a high-end R/C car engine (20+ amps)... So here are my questions: 1 - Could I lower the (...) (28 years ago, 22-Jan-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR