 | | LegOS??? What happened?
|
|
Anybody here happen to know what happened to the LegOS home page, (URL) has :LegOS moved? (...) (28 years ago, 16-Jan-99, to lugnet.robotics)
|
| |
 | | Re: LegOS??? What happened?
|
|
(...) Oops. false alarm. The server was saying that the page didn't exist earler this afternoon. (...) (28 years ago, 16-Jan-99, to lugnet.robotics)
|
| |
 | | Spirit + C++ Builder - help!
|
|
I am trying to use the spirit OCX from Borland C++ Builder, but when I try to add the ocx, I get errors : [Pascal Error] spirit.pas(24); Identifier redeclared: 'Spirit'. [Pascal Fatal Error] pasall.tmp(4): Could not compile used unit ' d:\program (...) (28 years ago, 16-Jan-99, to lugnet.robotics)
|
| |
 | | Re: CD-ROM used as Audio CD player
|
|
Never done it before, Alf, but here are a few hints. First off, learn about the IDE interface. These CD-ROM drives are cheaper than SCSI. Also, try to find source code for a CD player on-line, and examine it to see how it works. Last, why not just (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Capacitors Voltages?
|
|
May I know the voltage of the capacitors for the Handy-Board partlist. Or where can I find out (web site)? Thank u. (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | RE: gpu5x??
|
|
Step 8.2.1 of the Handy board Assembly insructions has code that lights a motor port LED when a TV remote is aimed at the infared demodulator it says to type the following at the IC prompt: while (1) {if (4 & peek(0x1000)) fd(0); else bk(0);} (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | help again
|
|
thanks to the immediate responses from the mailing list I was able to remove the connector bug from my handy bosrd and now my interface board is complete. But the handy board does not enter the download mode The sitution is as follows: Once I (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Continuous charging
|
|
Graham, J. Todd wrote: <snip> (...) If you use zap charge mode, you'll end up cooking your batteries unless the HB draws just the right amount of current. If you use any motors or other high current devices connected to the HB, trickle charge mode (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Grounding robots
|
|
(...) By ground, I just meant the HB ground. The important thing is just that everything in an electronic system share the same ground; voltages are relative, and the ground is just the shared reference point--the point arbitrarily defined to be (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: help again
|
|
check that the RxD line on the hc11 is properly pulled up to +5v through R15. also, make sure you are *HOLDING DOWN* the STOP button until the BATT light goes off. this wasn't clear from your msg. finally, try getting the HB into boot mode with the (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
|