 | | Re: Synchro drive in Lego
|
|
(...) Well, apparently, neither can I. :) Or I would have done it and posted it. :) I played with some stuff last night that ended in a dead-end. I'm not really sure the approach is fruitless, but I'm realizing as I go on that I'm much less creative (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Synchro drive in Lego
|
|
(...) could you not (I haven't tried this!) use a ratchet on the assembly so that axle rotation one way turns the assembly, and the other way drives the wheel? Stuart -- Did you check the web site first?: (URL) (28 years ago, 14-Jan-99, to lugnet.robotics)
|
| |
 | | FingerBoard Users?
|
|
I want to add a minimal board as a slave to my HandyBoard. My choices seem to be the FingerBoard, MiniBoard, and BOTBoard. At this point the FingerBoard is my first choice. Is there anyone here who has used this board? Any comments? Pros and cons of (...) (28 years ago, 14-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Synchro drive in Lego
|
|
(...) Yeah, but I can't think of a good way to ratchet the assembly. -Paul (pspeed@augustschell.com) (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
|
| |
 | | Unidirectional gearing - was Synchro drive in Lego
|
|
Here's a really simple (but not fool-proof way): Feed the motor output into a differential gear. The output from the differentials run out through beams and have a medium gear just outside the beam. Then suspend another beam from one end using a (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
|