 | | Expansion board motor outs???
|
|
I just wanted to verify something before I went and purchased the expansion board. Are the HB's motor outputs still available when using the expansion board. It is unclear in the doc. Thanks, Aaron (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Fw: RcxCC Joystick controls
|
|
Very simple. Write a little nc program that defines some tasks. Download it to the robot but don't run it. Here is a trivial example. After downloading it, the first button will start motor B and the second button will stop it. (Note that the order (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Pneumatic Tanks
|
|
(...) :-) (...) Syringes? That's injection needles, right? Hm. Now where do I get disposable syringes? Ah, I figure I'll find something I can use somewhere. Thanks for the idea! Fredrik (28 years ago, 11-Jan-99, to lugnet.robotics)
|
| |
 | | Re: ideas?
|
|
This should have worked - are you sure that you replaced your old Menus folder with the one in the extras folder? see ya (...) Associate Professor Department of Mechanical Engineering Tufts University Medford, MA 02155 email: crogers@tufts.edu (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
|
| |
 | | motor ports
|
|
Hi all, Is it possible to add more motor ports to the handy board by simply copying the existing motor drive circuit and putting them on the expansion header where the extra chip select lines are. if so what changes would be needed to make IC (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Book on Robot Sensors and Navigation Techniques.
|
|
As long as we're on the subject of books, I'd like to recommend "Mobile Robots" by Anita Flynn and Joe Lee Jones: (URL) a fascinating book, full of hands-on information. It contains step by step instructions for building several robots, including (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
|
| |
 | | Motor Ports
|
|
Hi all, Is it possible to add more motor ports to the handy board by simply copying the existing motor drive circuit and putting them on the expansion header where the extra chip select lines are. if so what changes would be needed to make IC (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | DL problems
|
|
I put together the HB shortly after it first became available. This is key because it worked-downloading and all. I put it down for a year because of family problems but all that time left it plugged in because of the Ni-cad. I feel that should (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Pneumatic Tanks
|
|
Fredrik Glöckner wrote in message ... (...) Yes, injection needles. Make sure to get a small gauge needle. Since the air is thin, you need a small restriction to see any reduction in flow. Drug stores normally have disposable needles, but you might (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
|
| |
 | | Re: The Ten Commandments of Lego
|
|
What happened to Thou shalt not glue Lego? (...) -- Technical Support requests should be sent to support@opendisc.com Joe Greene Technical Support OpenDisc Systems, Inc. Boulder, Colorado, 80301-2442 USA 303-546-0460 Joe_Greene@OpenDisc.Com (28 years ago, 11-Jan-99, to lugnet.robotics)
|