 | | Re: Voltage or resistance
|
|
I'm joining this thread a little late, so sorry if any of this has already been stated... For "passive" sensors, the RCX measures a voltage level, but since there's a pullup you may not get what you expect. If memory serves, the RCX ADC uses a 5.0V (...) (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | More input
|
|
After realizing that the input ports read resistance, I had an idea. Suppose that I used a network of switches and parallel resisters to differentiate between switches? Here's the circuit I have in mind: gnd-----+--[22k]------ switch --+ A | | (...) (28 years ago, 28-Dec-98, to lugnet.robotics)
|
| |
 | | (no subject)
|
|
After reading Dave's commentary on the RCX's ADC system, I did a few more test's, and found that I could easily predict the value that the RCX would produce for a given resistor. Just use the voltage divider formula - V=R2 / (10,000 + R2) and (...) (28 years ago, 28-Dec-98, to lugnet.robotics)
|
| |
 | | Mindstorms CD and Soft Windows
|
|
I have tried Virtual PC running Windows 95 on my G3 Mac and it doesn't quite work. The software itself runs (albeit with a bit of stuttering on the audio). The problem is the connection to the IR tower. The software doesn't recognize that the tower (...) (28 years ago, 28-Dec-98, to lugnet.robotics)
|
| |
 | | BotCode
|
|
I am impressed with the amount of work done with RCX and alternate systems for coding and control. I suppose this is old news to most of you but BotCode is a very nice package for those that want to ditch the Lego interface. (URL) Clemens, Associate (...) (28 years ago, 28-Dec-98, to lugnet.robotics)
|