 | | RE: expansion board - servo control
|
|
-----Original Message----- From: shsc9801@condor.stcl...dstate.edu [mailto:shsc9801@con...state.edu] Sent: Monday, December 21, 1998 1:39 PM To: handyboard@media.mit.edu Subject: expansion board - servo control Hi, I stopped working with the (...) (28 years ago, 21-Dec-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: RCX port information
|
|
(...) half the cost of a new RIS, let alone a RCX. But thanks for the link, I'll archive it for now... Jasper (28 years ago, 21-Dec-98, to lugnet.robotics)
|
| |
 | | Re: RCX Creator Software v 1.5
|
|
You got me..:) Your right...i should have said it only requires you to have the OCX installed and registered. Then everything sould work great. Im trying to get the opcodes setup and sending so i can do it natively but thats a bit of work...so maybe (...) (28 years ago, 22-Dec-98, to lugnet.robotics)
|
| |
 | | Re: I need a poloroid sonar board pinout.
|
|
Wayne Try this link. (URL) It shows modifications for interfacing the one step board to a microcontroller. I also have an old one step ($1 at a garage sale) but I have not tried the modifications shown for use with the handyboard. I have taken the (...) (28 years ago, 22-Dec-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: dc motor output control
|
|
On my first robot, I just took a resistor in-line and used that. It got very hot, though, and didn't work evenly (some of them must have started to burn out before the others did....) (28 years ago, 22-Dec-98, to lugnet.robotics.handyboard)
|