To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6641 (+5)
  updated my website...finally
 
Hi folks. I've finally added a few Mindstorms creations to the web page at (URL) (28 years ago, 19-Dec-98, to lugnet.build, lugnet.robotics)
 
  New robotics website online
 
Check out www.robotbuilders.com Add a link to your website in the Web Links section. Regards, Mark Williamson (28 years ago, 19-Dec-98, to lugnet.robotics)
 
  Re: a/d range
 
Hi friends! Thank you for the replies about this topic. Now I could get a Reference Manual too... The a/d range is determined by the references given to the VrefH and VrefL pins. But be careful about this: "There should be at least 2.5V between (...) (28 years ago, 20-Dec-98, to lugnet.robotics.handyboard)
 
  Re: All-around-the-robot bump detection
 
to Dennis Parker's point OK so you get this tube wired up to act as a switch. What's the energy drain on your batteries? What are the voltages required to exceed the limit value of the actuator? It sounds more accurate than an air filled tube (...) (28 years ago, 20-Dec-98, to lugnet.robotics)
 
  Re: Vertical Mill
 
Robert Fay writes: > I have posted pictures and a QuickTime movie of my new vertical mill at > (URL) adding all of these to the ``Building'' section of the list web site at (URL) It would be great to know if the model is ``Mindstorms-Pure''. I'm (...) (28 years ago, 20-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR