 | | Re: Handyboard Kit.
|
|
(...) That is a mistake in the directions. They should be 47uF axials, like you have. I will fix this now. -Fred (29 years ago, 17-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | encoders
|
|
(...) if your counting program is written in IC, and not assembly lang, it might be too slow and occasionally miss counts. -F (29 years ago, 17-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Servo Motor
|
|
Hello! Could anybody please tell me the proper step in controlling the servo motor by HB ? ^s I connected the servo motor to the HB and typed in the servo motor control functions but none of them are working... Thanks in advance. (29 years ago, 17-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Where can I get GP1U52X IR sensors?
|
|
Hello there Handyboard users in the world, I read a lot about these IR sensors: Sharp GP1U52 or GP1U56Y. I would like to use some of these sensors in my own robot, that I build around a 8051 and a Forth interpreter. Now it has a few bumper switches (...) (29 years ago, 17-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo Motor
|
|
Hi Hajime, Here's the rundown for connecting the servo to the Handy Board: 1) Assuming you're using digital port 9, you will need a connector like this: _ =====| |== <--- connect the WHITE wire from the servo here | | <--- remove pin to polarize (...) (29 years ago, 18-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Re: encoders
|
|
(...) It's an icb file, based on the encoders.asm source included with IC. (29 years ago, 18-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | BackLite LCD
|
|
Hello! Does anyone know of a good backlite LCD display that could be easily be used with the Handy Board (hitachi chipset)? Thanks.. joeo@symtec.com (29 years ago, 18-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | web site update
|
|
Hi all, I've made some cosmetic changes to the HB web site. If anyone has any feedback, positive or negative, i'd like to hear it. Thanks, Fred (29 years ago, 19-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Electronic Compass?
|
|
Has anyone gotten a relatively cheap (<$100) electronic compass, like the KVH100, to i/f to the Handyboard? I believe it uses the SPI architecture which matches the Handyboard. * Michael L. Ross/C33 | Lockheed Engineering & Sciences Co.**** * (...) (29 years ago, 19-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Electronic Compass?
|
|
(...) I messed with the Vector2X (~$50 from Jameco) on the miniboard. It was supposed to have a SPI compatible bus, but I couldn't get it to work with SPI bus. I got it to work with one of the other IO ports. Using the handyboard with IC might make (...) (29 years ago, 19-Jul-96, to lugnet.robotics.handyboard)
|
