 | | Re: Delphi developers
|
|
John: I haven't heard about Delphi, but some have created other ways to program the RCX. See my Mindstorms page and look under the Alternate Programming Environments section. The page is located at (URL) Nelson nelsonb@vii.com (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | Re: DC Motor movement
|
|
(...) Each motor may have slightly different characteristics even though they may be the same brand and model. This is what you are probably seeing. The ultimate solution is to use a feedback mechanism, like a shaft encoder, on the motors and use (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: RCX Command Center
|
|
Found the problem. I normally run code like this from the D: drive. It seems that unless I have the NQC dir on the C: then it can not find "Command.com". Once I moved the NQC to the C: and remapped my icon, then it alled worked. Would it be (...) (28 years ago, 9-Dec-98, to lugnet.robotics)
|
| |
 | | unsuscribe
|
|
unsuscribe (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | ...-help@...
|
|
(28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | -help@
|
|
(28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | autostart of program in mindstorm
|
|
You can use my free RCX Command Center. You can select the program, run it or stop it, and even run individual tasks. (Of course, it also does a lot more.) See my web page for more info: (URL) Overmars (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | Communicating with IR tower
|
|
The standard way for doing this is to use variable 0 on the RCX. Te robot can set it to a specific valu when it needs something. The PC can use the SetEvent command and the VariableChange event handler to check whether the variable changes. (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | Delphi developers
|
|
RCX Command Center was written in Delphi using the spirit.ocx. It work very easy. (Only note that the On command to switch motors on is called On_ because on is a reserved word in Delphi.) But if you want to write programs to download to the RCX, I (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | Re. RF data link
|
|
If the data tx/rx modules can't handle TTL levels is there any reason to have the interface board at the PC end ?, why not replace the serial cable going to the PC with the rx/tx modules ?. Surely this should work. John (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|