 | | Re: Keeping the piece(s)
|
| (...) I have about 6 "RubberMaid" tubs that contain all of my current pieces. Each box has a "topic" being Technics, Standard Legos, Special Legos, bases, etc... I am soon going to get a set of "Sandwich Keepers" to keep together very special pieces (...) (28 years ago, 8-Dec-98, to lugnet.robotics)
| | |  | | RE: Keeping the piece(s)
|
| Personally, I've gone a little nuts. I spend 80% of my 'lego time' sorting pieces. Bought two large tackleboxes. One's motors, sensors, rods, connectors and funky pieces. The other's for the small pieces, like 2x1 blocks & flat lengths. I use three (...) (28 years ago, 8-Dec-98, to lugnet.robotics)
| | |  | | RE: Serial interface/ RF data link
|
| <<snip>> Unfortunately, I have not had any luck. This brings me back to the first point- is it possible to use the serial interface board by just providing the tx and rx lines? <<snip>> In short, no. The serial interface board takes power from the (...) (28 years ago, 8-Dec-98, to lugnet.robotics.handyboard)
| | |  | | persistent var's in IC
|
| Has anyone had problames with the Handyboard, IC 3.2 and 'persistent' variables? the following declaration works fine : persistent float i; but using an array: persistent float battery_voltage[ 320 ]; always causes an error while downloading : IC> (...) (28 years ago, 8-Dec-98, to lugnet.robotics.handyboard)
| | |  | | Re: Serial interface/ RF data link
|
| To properly comunicate with any PC you need to convert your TTL TX and TTL RX signals coming from the Handy Board to RS232 voltage levels. The charging board contains this interface IC called the "MAX232" The power wire is required unless you are (...) (28 years ago, 8-Dec-98, to lugnet.robotics.handyboard)
| |