To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6071 (+5)
  communication between two boards
 
I use handy board and xc40 board(It has xc4010 FPGA chip) The problem is that they must communicate each other. But I don't know how I can make them communicate. In Q&A(at mit's handy board home page) it says that SPI pin can be used as digital (...) (28 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
 
  bugs 'n bumpers
 
It's bad enough trying to explain to friends and family why I play with Lego, but the ultimate humiliation came when I was down on all fours, nose down, rear end up, pursuing a roach to study. You set me up, right? The marvel of engineering tucked (...) (28 years ago, 7-Dec-98, to lugnet.robotics)
 
  Re: Extra output for clocking (Using Hardware Output Compare)
 
Hugo: I am not going to be able to answer this one fully. We will need to hear from others on the list to hear how to mix assembler code into an IC program, how to have the IC program modify assembler variables, and how to set up interrupt service (...) (28 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
 
  communication problem
 
Hi everybody I seek someone who can help me. I use handy board and xc40 board(it mounts xc4010 FPGA chip). And I have to make two board communicate each other. But there is a problem that I don't know the method. In handy board's F&Q page, It says (...) (28 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
 
  Re: LEGO Hexapod Walker
 
(...) Actually you could use the differential technique discussed before to measure their phase directly, if you're short of sensors (as one is...). stephen (28 years ago, 7-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR