 | | Re: Bumper Ideas Needed
|
|
(...) I've had the best luck building wide range bumpers by making the switch normally pressed, and having it go to the 0 state when the bumper hits something. For a small round bumper I would try and do something where I have an axle centered over (...) (28 years ago, 4-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Bumper Ideas Needed
|
|
(...) It's almost instantaneous. The problem is that I'm trying to map a room mapper and I don't want it to move it's position because of an impact so I know where it stands. Besides, the motors can make the bot move very fast! (...) Great idea!!! (...) (28 years ago, 4-Dec-98, to lugnet.robotics)
|
| |
 | | RE: Sonar question
|
|
That will only allow one half of the conversation. I suppose you could run with two kits, one receive, one transmit, both tuned to different frequencies. Another suggestion might be one of the cordless, battery operated intercom system units. Most (...) (28 years ago, 4-Dec-98, to lugnet.robotics.handyboard)
|
| |
 | | Fw: Fw: Predator/Prey thoughts ...
|
|
That assumes that it is just as easy for the bot to reach and detach its own scalp as it is to get to other's scalps. I'd be willing to bet that the increased range and mobility of the scalping apparatus would render it too brittle or too hard to (...) (28 years ago, 4-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Apple Microphones
|
|
(...) I would only caution you that there are two types of microphones for the Mac -- regular mics and "PlainTalk" microphones. I suspect you are talking about a PlainTalk mic. The obvious distinguishing difference is the "longer than normal" male (...) (28 years ago, 4-Dec-98, to lugnet.robotics.handyboard)
|