To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *5646 (+5)
  Re: Worm Drive Question
 
(...) Nope, not me. I never cut on purpose, and anything that breaks gets tossed. (28 years ago, 28-Nov-98, to lugnet.robotics)
 
  Re: Worm Drive Question
 
(...) tend to slide on the axle over time? (28 years ago, 28-Nov-98, to lugnet.robotics)
 
  Re: Choosing a shaft encoder?
 
(...) I've had good results using the Hall-effect magnetic sensors that Patrick Hui sent with my HandyBoard. I glued magnets into three of the six holes in a Lego pulley wheel and glued the sensor into a small Lego brick. I don't know the part (...) (28 years ago, 28-Nov-98, to lugnet.robotics.handyboard)
 
  Re: CyberMaster memory limit?
 
Your program generates a .RCX file of 440 bytes. I've created one with 452 that works OK, but had to stop around that number because after more 2 or 3 lines of code the last task simply disappeared (my program had 1 main plus 3 tasks). I guess the (...) (28 years ago, 28-Nov-98, to lugnet.robotics)
 
  Re: Worm Drive Question
 
Try a little white glue. The glue helps prevent slippage and can be easily removed with warm water. Another option is a low-temperature "hot" glue gun. Many of the "hot" glue gun glues can be removed with vinegar. Use these at your own risk. matt (...) (28 years ago, 28-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR