Subject:
|
Re: Choosing a shaft encoder?
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sat, 28 Nov 1998 17:40:44 GMT
|
Original-From:
|
Will <WILLBAIN@CS.UMT.EDUstopspam>
|
Reply-To:
|
WILLBAIN@CS.UMT.EDUnomorespam
|
Viewed:
|
2499 times
|
| |
|
|
Lewis Patterson wrote:
> As a neophyte robot builder and HandBoard user, may I ask
> for help in choosing the best shaft encoder?
I've had good results using the Hall-effect magnetic sensors that
Patrick Hui sent with my HandyBoard. I glued magnets into three of the
six holes in a Lego pulley wheel and glued the sensor into a small Lego
brick. I don't know the part number, but I'm sure that the usual
sources (Digikey, Mouser, etc.) probably have similar items. Good luck.
--Will
, ,
__@_/ \_@__ |/
| /__, o @_/
)\ ) ( \ (\/\\,
~~~~~~~~~ ' ` ~~~~~~~~~~~ ` ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Wendy Parson, If the world should blow itself up, the last
Will Bain, audible voice would be that of an expert
& Tatoosh saying it can't be done. --Peter Ustinov
|
|
Message is in Reply To:
 | | Choosing a shaft encoder?
|
| As a neophyte robot builder and HandBoard user, may I ask for help in choosing the best shaft encoder? What vendor/supplier should I use? The current project is a very simple robot with a goal of accurate navigation. Thanks! (26 years ago, 28-Nov-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
