To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *5541 (+5)
  RE: legOS
 
(...) For some Pilot <--> RCX information take a look at (URL) if you haven't yet. This honestly is quite lagging on progress, but I _have_ been working on it in my very limited spare time. Hopefully within a week or two I'll have some much more (...) (28 years ago, 25-Nov-98, to lugnet.robotics)
 
  RE: Worm Drive Question
 
(...) Sorry I Lost you there, what do you mean by cut Lego? Tim (28 years ago, 25-Nov-98, to lugnet.robotics)
 
  Re: Worm Drive Question
 
(...) I mean cut threads (like on a screw) into the axel using a thread cutting tool (part of a tap and die set available at most good hardware stores). Check out (URL) near the bottom of the page. (28 years ago, 25-Nov-98, to lugnet.robotics)
 
  RE: Worm Drive Question
 
(...) As in run an axle through a die to give it a thread, then put nylon bolts on it. Couldn't you just get some threaded rod, and spare your Lego (and avoid heresy :) ? Daniel "Dan'l" Miller Senior, School of Aeronautics and (...) (28 years ago, 25-Nov-98, to lugnet.robotics)
 
  Re: legOS
 
Has anyone be able to unpack the LegOS file. I have the CYGNUS GCC on my Wintel system. Using GZIP I get this error "Invaled Compressed Data - Format Violation" I would like to try out LegOS and see if it will allow memory storage/retrieval. I have (...) (28 years ago, 24-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR