 | | motor port problem
|
|
hi, i really need help urgently. Currently, I running my robot using 2 DC motor on port 2 & 3. I used external power supply to the L293D (pin 8). I did not cut the trace. I used Alkaline battery 12V recharagable . when I run my robot, it is running (...) (28 years ago, 16-Nov-98, to lugnet.robotics.handyboard)
|
| |
 | | correct procedure when downloading pcode_hb.s19
|
|
hi I am at present building a handyboard from Fred's assembly manual, however it appears I might have a problem. I have connected the serial interface board to the handyboard. The hb is placed into bootstrap mode by holding down the stop button. The (...) (28 years ago, 16-Nov-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: MindStorms on NT
|
|
(...) I've been using Lego Robotics since it's release date (oct. 3 I think) with NT and have had no problems yet. -Ang (28 years ago, 16-Nov-98, to lugnet.robotics)
|
| |
 | | Re: The IR beacon, was Re: Homebrew sensors?
|
|
(...) And if you mounted some sort of plug on the front of your robot it could mate with a matching socket when it entered the garage and wait there until its batteries were recharged! (28 years ago, 16-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Spirit.OCX & Starting a Program
|
|
(...) Doesn't the mysterious opcode d2 allow you to do that? Or am I missing something? }}Date: Sun, 25 Oct 1998 15:35:08 -0800 (PST) }}From: Kekoa Proudfoot <kekoa@Graphics.Stanford.EDU> }}To: Lego Robotics <lego-robotics@crynwr.com> }}Subject: Re: (...) (28 years ago, 16-Nov-98, to lugnet.robotics)
|