To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *5251 (+10)
  Re: Homebrew sensors?
 
In article <Pine.GSO.3.96.98111...129.6050E- 100000@expert.cc.purdue.edu>, Daniel Miller <danielmi@expert.cc.purdue.e du> writes (...) Ah. A jet engine expert. It always puzzled me how the hot air knows it is supposed to go out of the hole at the (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
 
  Re: Homebrew sensors?
 
does pressure difference make any sense?..:-) Selçuk (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
 
  Re: NiCd Charger
 
Russ: In a message dated 98-11-13 04:48:38 EST, you write: << ... power rating of resistor = 15Volts * 200mA = 3Watts Series resistor needed = 75 Ohms @ 3 Watts. ---...--- ------- The 75 Ohms bit seems reasonable to me but 3Watts must be way to (...) (28 years ago, 14-Nov-98, to lugnet.robotics.handyboard)
 
  Re: moving in a straight line with two motors?
 
---...--- (...) attached. (...) is (...) is (...) sheet (...) I expect that the "motor is shorted" state is achieved by turning on either both high-side drive FET's or both low-side drive FET's, and niether of these combinations would provide a high (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
 
  Re: Cybermaster protocol?
 
(...) If I'm not mistaken, Peter Ljungstrand has compiled this information at (URL) (28 years ago, 14-Nov-98, to lugnet.robotics)
 
  Mindstorms meeting in Boston
 
Hey -- any Boston area people should come to the Construction Site tomorrow (Nov 15) from 7-9 for a Mindstorms show-n-tell/get-together. Details (such as there are) on lugnet in lugnet.loc.us.ma.bos (28 years ago, 14-Nov-98, to lugnet.robotics)
 
  How to receive messages from the CuberMaster unit?
 
I'm currently using Dave Baum's NQC on a Linux system with CyberMaster (thanks to Peter Ljungstrand's adaption), and am very happy with that. However, I often find myself in the position where I want to transfer data from the CyberMaster mobile unit (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
 
  Re: moving in a straight line with two motors?
 
(...) Image processing? Proportional control pushes back proportional to deflection (i.e. it simulates a spring). Derivative control pushes back proportional to rate of deflection (i.e. it simulates dynamic friction). Integral control pushes back (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
 
  Re: moving in a straight line with two motors?
 
(...) Perhaps you're asking too much of them. Try toning down the pendulum; that is, give it some length below the hinge point as well. As long as it's still top-heavy you're still technically an inverted pendulum, and the added mass below the pivot (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
 
  Re: Monitoring household power consumption
 
Hi all, I found an interesting article by Don Lancaster in May 1998 issue of the magazine, Electronics Now. Maxim makes a chip (MAX125) that will convert accurately four channels of analog data to 13 bits accuracy, plus talk about a device for $79 (...) (28 years ago, 14-Nov-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR