To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *5231 (+5)
  Re: how to adapt a voltage signal?
 
You could use resistors to make a 1/10 voltage divider. If you need high input impeadance, you could build an Op-Amp circuit to divide the voltage by 10. Most ADC chips have a pin that is the reference voltage for the high end of the scale--set this (...) (28 years ago, 13-Nov-98, to lugnet.robotics.handyboard)
 
  Re: moving in a straight line with two motors?
 
(...) Hm. So I just reviewed the data sheet again, and it seems that there is indeed a significant current when the motor is shorted. That sucks. -Kekoa (28 years ago, 13-Nov-98, to lugnet.robotics)
 
  Re: Homebrew sensors?
 
Daniel Miller wrote in message ... (...) Daniel, I could not help but notice that you are into rockets. If so, then whoosh-bang is not the way to go. I think bang-whoosh makes a much better rocket since it should have a loud ignition, then a (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
 
  FT639 and Lynxmotion IRPD
 
Has anybody try to interface a FT639 to a Handy Board ? Has anybody try to interface a Lynxmotion IRPD kit to a Handy Board ? (28 years ago, 13-Nov-98, to lugnet.robotics.handyboard)
 
  Re: Homebrew sensors?
 
There is a single channel sound sensor on my web page: (URL) was really designed for picking up loud noises like claps. What you want would require two mics and a circuit that would take the difference between the sound levels. Better yet it should (...) (28 years ago, 13-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR