 | | Re: Controling LEGO trains via Decta Control Lab
|
|
(...) To change the speed of the pulsing, you change the frequency. Frequency is measured in Hz. You want more Hz. To change the speed of the train, you increase either the duty cycle or the voltage. The duty cycle is the percentage of time that the (...) (28 years ago, 29-Oct-98, to lugnet.robotics)
|
| |
 | | Re: CYBERMASTERS - how it works ?
|
|
Rene Virsik wrote in message ... (...) program (...) can (...) radio (...) Both. Pplease read yor answer in here. Eric (28 years ago, 29-Oct-98, to lugnet.robotics)
|
| |
 | | Config Register error
|
|
When I download the pcode file using either HBDL or DL the pcode itself is loaded successfully but I then get an error from both programs saying the config register is set to 0xFF. I retried several times but the config register always reads 0xFF. I (...) (28 years ago, 29-Oct-98, to lugnet.robotics.handyboard)
|
| |
 | | IRDA and Handyboard?
|
|
Hi all, Electronics Goldmine has some notebook pc IRDA ports for $2! (URL) I think it would be Great to use a couple of these to get 2 Handyboards to talk with eachother. Or, get one handyboard to talk with my Notebook PC (which already has an IRDA (...) (28 years ago, 29-Oct-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Controling LEGO trains via Decta Control Lab
|
|
10Hz is nowhere near fast enough to control a train motor using PWM (pulse width modulation). You need at least 100Hz, and higher would be better. Any of your suggestions will vary the speed of a motor, but the most common is varying the duty cycle. (...) (28 years ago, 29-Oct-98, to lugnet.robotics)
|
| |
 | | Re: Controling LEGO trains via Decta Control Lab
|
|
I was hoping someone would post a solution to the software platform. I would even kill for just the low level API to the control lab direct and write my own Visual Basic OCX for it. The LOGO development environment is a bit forgien to me and is (...) (28 years ago, 29-Oct-98, to lugnet.robotics)
|
| |
 | | Re: Voltage for the DC motor
|
|
from the FAQ: Using a Separate Motor Power Source: (URL) Eric (...) (28 years ago, 29-Oct-98, to lugnet.robotics.handyboard)
|
| |
 | | Smooth PWM in C
|
|
L.S. I wonder if anybody has got the smooth pwm routines in C? This would help me a lot understanding this particular bit and adapting it to my own needs... Thanks, Jaron Paludanus (28 years ago, 29-Oct-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Motor output
|
|
On Wed, 28 Oct 1998, Eric Noyau wrote: <snip> (...) way into the supported release of the pcode and libraries? This is a real improvement over the standard one... I believe that IC version 3.2 includes the PWM stuff already. --Will (28 years ago, 30-Oct-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR Detection
|
|
(...) The Sharp IR detector is designed to respond only to modulated IR signals. The card from Radio Shack will indicate whether the LED is illuminated, but it won't tell you whether it's modulated at the proper frequency. Perhaps that could be the (...) (28 years ago, 30-Oct-98, to lugnet.robotics.handyboard)
|