Subject:
|
Config Register error
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 29 Oct 1998 13:43:36 GMT
|
Original-From:
|
wengd@(spamless)optionshealthcare.com
|
Viewed:
|
1695 times
|
| |
| |
When I download the pcode file using either HBDL or DL the pcode itself
is loaded successfully but I then get an error from both programs saying
the config register is set to 0xFF. I retried several times but the config
register always reads 0xFF. I am using an E2 (2k eeprom) version of the
HC11. I tried using the -eeprom (Burn Eeprom) switch but got the same
result. What could be keeping the config register from being reset. I used
this processor in a previous project if that matters...
Any suggestions... I'm stuck...
-Drew
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|