 | | Re: the LEGO CNC-Machine
|
|
"Bob Fay" <rgfay@earthlink.net> wrote in message news:Jnt8MF.n84@lugnet.com... (...) This is one of mine. Note the left worm is out if sequence by 1/4 turn with the other two. this is putting pressure on the dual racks to remove the backlash. (URL) (...) (19 years ago, 3-Sep-07, to lugnet.robotics.rcx)
|
| |
| | Re: the LEGO CNC-Machine
|
|
"daniel" <daniel.formatc.at.gmail.com> wrote in message news:Jnt54J.Jpy@lugnet.com... (...) I liked the technic beams because I could lock them together. I imagine double wide bricks can make a good foundation. Put an ocassional beam in to allow (...) (19 years ago, 3-Sep-07, to lugnet.robotics.rcx)
|
| |
| | Re: the LEGO CNC-Machine
|
|
(...) thanks! it's nice to get that kind of feedback from someone who's not new to lego mills :) (...) yes. you can see it in my diagrams again, the cutter hangs over the table pretty far: (URL) i'm not sure yet how exactly i will manage to make it (...) (19 years ago, 3-Sep-07, to lugnet.robotics.rcx, FTX)
|
| |
| | Re: the LEGO CNC-Machine
|
|
"daniel" <daniel.formatc.at.gmail.com> wrote in message news:Jnszy4.7qA@lugnet.com... (...) very well done. Your slider design is also very good. The table is supported in all directions. You have made it simple and effective. Good engineering! (...) (19 years ago, 3-Sep-07, to lugnet.robotics.rcx)
|
| |
| | Re: pbLua GUI ???
|
|
(...) This is starting to look pretty promising as a standard IDE. I will do my part and install Eclipse here and get the instructions updated from Christian's instructions. Once we get a decent IDE the pbLua system may be almost ready for "everyone (...) (19 years ago, 3-Sep-07, to lugnet.robotics.nxt)
|
