To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4386 (-5)
  help!
 
Dear hb-fans, I'm currently trying to use the handy board to run a 12-legged robot. I've tried to power the motors directly from the hb motor output but apparently the current supplied is too low. Is there any simple method of powering my motor and (...) (28 years ago, 21-Sep-98, to lugnet.robotics.handyboard)
 
  newbie needs help.
 
I just bought a pre-assembled Handyboard. And I am about to explore it. Already I am having problems. I am trying to go into the bootstrap download mode as described in the manual, but it doesnt work. I turn off the handy board, hold down the STOP (...) (28 years ago, 21-Sep-98, to lugnet.robotics.handyboard)
 
  stepper motor speed
 
Hi, Recently, I have connected the wires out from the 4 motors ports on the HB and then directly connected to the driver L298.Next, the o/p of L298 is connected to the stepper motor which drawn 3A. I supply 4A parallel to the 2 motors. Hence, each (...) (28 years ago, 20-Sep-98, to lugnet.robotics.handyboard)
 
  Re: lcd screen pinouts
 
the LCD should work fine. On the HB, pin 1 is on the top left, and pin 14 is on the top right. Just hook them up in order and you're all set. Fred In your message you said: (...) (28 years ago, 18-Sep-98, to lugnet.robotics.handyboard)
 
  lcd screen pinouts
 
Hi I have purchased an lcd screen for the handyboard, however it's not the ridji-dij lcd. The pinouts are as follows pin symbol function 1 Vss 0v 2 Vdd 5v 3 Vo contrast adjustment 4 RS register select 5 R/W read/write 6 E enable signal 7 DB0 databit (...) (28 years ago, 18-Sep-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR