To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *43659 (-10)
  Re: multiplexing Spybot inputs?
 
(...) Some time ago, I have sugested the use of the VLL port to make an interface to connect a couple of lego light sensors to the spybot. The ideea was to have an analog device (powered by a 9V bov) that would just switch on a sensor, then switch (...) (21 years ago, 8-Jan-06, to lugnet.robotics.spybotics, FTX)
 
  NXT - ARM7's and USB
 
Im not a chip guru, can someone explain why the lego speck says the USB is input only? The PDF's for the ARM7 chip set(s) this could be, state the on board USB controller is bidirectional. questions, questions, questions..... Chris (21 years ago, 8-Jan-06, to lugnet.robotics)
 
  Re: Mindstorms NXT programming languages
 
Hi Brian, (...) On the RCX Lejos is about that much faster than the standard firmware, and we have 1ms timer resolution. (...) You also get those in Lejos, and compared to NQC it can access more memory. Jürgen (21 years ago, 8-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
(...) I just saw Lego's definiton of a servo motor. It resembles a industry servo, not a hobby servo. In the hobby servo, the closed loop is done in the servo electronics, but in the industry servo, the closed loop is done in the controller. (...) (21 years ago, 8-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
I am not very familiar with the NXT platform but as it sounds now could you possibly plug a USB Flash memory stick into the USB port (or connector) on the NXT and use it for data storage? - John (...) (21 years ago, 8-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT and memory
 
(...) In the case of room mapping, would speed be so important? Isn't it it in the ms range? (A lot compared to an instruction cycle, but good enough for a moving bot) (21 years ago, 8-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT and memory
 
(...) You could use a bit per square inch (21 years ago, 8-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
(...) I bought my mindstorms from pitsco to save $50... (cost $150) (21 years ago, 8-Jan-06, to lugnet.robotics)
 
  Re: Mindstorms NXT programming languages
 
(...) Actually, when using the standard firmware speed is very much a concern with the RCX for me... and others, if things like the Swan firmware are anything to go by. Currently, using NQC, I need to examine the bytecode generated to try to (...) (21 years ago, 8-Jan-06, to lugnet.robotics)
 
  Re: new Mindstorms servos?
 
(...) Although I think there's two things to watch out for here. First, if you have continuous monitoring of the encoders, you could have speed control (in other words, the speed in the video may not be the maximum, but something less). Second, (...) (21 years ago, 8-Jan-06, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR