To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4361 (-5)
  Re: bootstrap mode in assembling the HB
 
yes, RP4 is four isolated resistors, and this being part of the serial line circuit, definitely explains your problem if you are using the common-terminal style. you can just install four 1K resistors if you don't have the correct r-pack handy. fred (...) (28 years ago, 9-Sep-98, to lugnet.robotics.handyboard)
 
  bootstrap mode in assembling the HB
 
hi At present I am up to section 4.4, "serial line and stop switch". I have installed all the components as per the section but when testing by applying power and holding down the stop switch, the HB will not go into bootstrap mode. I have not (...) (28 years ago, 9-Sep-98, to lugnet.robotics.handyboard)
 
  Fw: Current Rating use on HB
 
(...) that (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  encoder use in stepper motor
 
hi, How can i use my self build encoder to locate the position when my robot reach a position ? Is it suitable to use a self build encoder together with the stepper motor? The self build encoder consists a photoelectric reflector sensor mounted (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  Re: IC dip 120 or Ic dip 210
 
(...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR