To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4351 (+10)
  Re: [LCD screen]
 
Like this: printf("\n"); printf("\n"); That's all there is to it. (...) (28 years ago, 4-Sep-98, to lugnet.robotics.handyboard)
 
  Bootstrap download mode
 
Hi I have been trying to get the HB into bootstrap mode without much success. Following the instructions in the manual, I held down the STOP button while turning on the HB. The red and green LEDs were supposed to turn on for a short period of time (...) (28 years ago, 5-Sep-98, to lugnet.robotics.handyboard)
 
  Re: Serial Communication with HP48 calculator
 
(...) not that i am aware of. you could connect to the HB's phone jack as long as you don't have to talk to interactive c and your calc at the same time. see the FAQ serial answer. (...) the SPI is for high speed SYNCHRONOUS comms (data and clock (...) (28 years ago, 7-Sep-98, to lugnet.robotics.handyboard)
 
  using interupts from IC
 
I want to drive 3 stepper motors form a handy board. I have the code running now as a dll under windows. What Im trying to gain from the HB is using interupts, so I can remain in connntact with the control while the steps time out- right now I just (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  IC dip 120 or Ic dip 210
 
Hi, Is there anybody came across such IC Dip 210 or Dip 120 ? rgds, chia (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  Current Rating use on HB
 
Hi, What is the current rating allow to be use on the HD if currently I am using a stepper motor of rating 4.5V and current 3Amp ? Is it all right directly plug it into the HB? How should I increase the acceptable current rating on the HB? How (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  Re: IC dip 120 or Ic dip 210
 
(...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  encoder use in stepper motor
 
hi, How can i use my self build encoder to locate the position when my robot reach a position ? Is it suitable to use a self build encoder together with the stepper motor? The self build encoder consists a photoelectric reflector sensor mounted (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  Fw: Current Rating use on HB
 
(...) that (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  bootstrap mode in assembling the HB
 
hi At present I am up to section 4.4, "serial line and stop switch". I have installed all the components as per the section but when testing by applying power and holding down the stop switch, the HB will not go into bootstrap mode. I have not (...) (28 years ago, 9-Sep-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR