 | | Re: Basic NQC Problem
|
|
(...) There's a couple of ways to fix it. One is as Raplph said - have the first task start up a dedicated second task that does nothing more than look for a touch in a very tight loop. Very roughly, it would work something like this: task (...) (21 years ago, 13-Nov-05, to lugnet.robotics)
|
| |
 | | Re: pre-releases brickos-0.9.0/lnpd-0.9.0 avail. for testing/feedback
|
|
Hi, I'm having problems getting dllx to work. I expanded the lnpd 0.9.0 zip file from sourceforge. I did ./configure and make with no problems or error messages. Now, I run lnpd with "lnpd --nolock". Then I do "dllx test.lx" and the green light on (...) (21 years ago, 13-Nov-05, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Basic NQC Problem
|
|
(...) Big place to ask your questions here. I'll try to answer it, best i can. (...) You should switch of the motors and StopAllTasks in the check_sensor() task, if the bumper is hit. The main task does not furthermore look like that algorithmic as (...) (21 years ago, 12-Nov-05, to lugnet.robotics)
|
| |
 | | Control Lab Connection help
|
|
Greetings, I have been trying program Control Lab using robolab. However, when I go to download all I get is the "Start CLI-1" window with a red 'X' through the reconnect icon. I am using the Control Lab interface start icon. I have tried several (...) (21 years ago, 12-Nov-05, to lugnet.robotics, lugnet.dacta)
|
| |
 | | Re: Is it possible for a robot to count studs?
|
|
(...) Yes. The rotation sensor does occasionaly mess up at low rotation speeds, but this issue can be overcome by gearing up the actual rotation to higher speeds, and then dividing it back down in software. Kev (21 years ago, 12-Nov-05, to lugnet.robotics)
|