To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *42629 (-5)
  Re: My First GBC - A Humble Ball pump
 
On Thu, July 14, 2005 10:49 pm, Chio Siong Soh said: (...) ... (...) CS, That's a nice start. Like your local kids, I'm looking forward to your next GBC creations. You just need three or four more, and you can make your own loop. Then, the (...) (21 years ago, 15-Jul-05, to lugnet.robotics)
 
  Re: different output power at different ports?
 
You're absolutely sure it's not a sticky wheel? Thomas (...) (21 years ago, 15-Jul-05, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab)
 
  My First GBC - A Humble Ball pump
 
After amassing a heap of the soccer balls from Steve Hassenplug and Larry Pieniazek, I felt kinda guilty of not having a product to show off. So I got down and built my very first GBC, a humble ball pump to get the balls moving. (URL) It uses the (...) (21 years ago, 15-Jul-05, to lugnet.robotics, FTX)
 
  Re: different output power at different ports?
 
(...) This sounds to me like a good tactic. Your program might have some issue with turning in one direction vs another. (...) I also have trouble believing variations in parts (except the motors themselves) will cause this much difference. Ralph (21 years ago, 14-Jul-05, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab)
 
  Re: different output power at different ports?
 
(...) Okay - did you try a simple program going in a straight line, and check how much it veered after a few meters? Unfortunately - it does not sound an entirely unlikely problem - if there are variations between the h-bridges (general (...) (21 years ago, 14-Jul-05, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR