 | | Re: caster wheel design
|
|
I had a similar problem once, when my Cybot had a broken castor - I found that the Lego axle made a snug fit in the cavity intended for it - however it was bending and under a lot of tension. My solution was to use axle-joiners((URL) and 2 unit long (...) (22 years ago, 31-Mar-05, to lugnet.robotics)
|
| |
 | | urgent! lejos run error
|
|
Hi guys, im trying to get the Lejos vision package set up on my computer for a university project. I've got the motion example that comes with the package compiling but I'me still getting an error when I try to run it: Exception reading (...) (22 years ago, 31-Mar-05, to lugnet.robotics.rcx.java)
|
| |
 | | Re: caster wheel design
|
|
(...) heck I ended up with any of them. They work great however. (22 years ago, 31-Mar-05, to lugnet.robotics)
|
| |
 | | Re: caster wheel design
|
|
(...) This the one you mean? (URL) (22 years ago, 31-Mar-05, to lugnet.robotics)
|
| |
 | | Re: caster wheel design
|
|
(...) You can actually do that one better - use a 2x2 plate with offset wheel holder on the bottom, & you can dispense with the 2x3 plate. I browsed Peeron & Bricklink and couldn't locate it, but they're handy for microcasters. (22 years ago, 31-Mar-05, to lugnet.robotics)
|
| |
 | | Re: Alternate connectors
|
|
You even do not need to cut your existing LEGO wires visit (URL) cost effective too Nitin (...) (22 years ago, 30-Mar-05, to lugnet.robotics, FTX)
|
| |
 | | Re: Alternate connectors
|
|
(...) One of the NALUG members did the very thing you are talking about. I believe he used a connector from Radio Shack but I will double check or have him check the forums. Mike (22 years ago, 30-Mar-05, to lugnet.robotics, FTX)
|
| |
 | | Alternate connectors
|
|
I am trying to find a suitable connector that will let me cut up and extend the regular mindstorm wires, as well as to connect to custom built sensors. I have seen that some people have used (URL) Molex connectors> (URL) but I can't seem to find (...) (22 years ago, 30-Mar-05, to lugnet.robotics, FTX)
|
| |
 | | Re: caster wheel design
|
|
(...) Another "microcaster" is the style used in "ERBIE the Robocar" discussed here (URL) made with a 2x2 turntable, a 2x3 plate, and a single wheel (URL) works surprisingly well, so long as 1) The weight isn't huge and 2) the surface isn't too (...) (22 years ago, 30-Mar-05, to lugnet.robotics)
|
| |
 | | Re: caster wheel design
|
|
(...) Move the other wheels or the CG so that the caster doesn't support much weight. No matter what your design, a caster that carries a lot of weight will not work well. The large turntables will have a lot of friction when carrying a lot of load. (...) (22 years ago, 30-Mar-05, to lugnet.robotics)
|