 | | Re: Inclinometer for Handyboard
|
|
greetings everyone, this is a reminder to please NOT send 1MB attachments to the list! In the guidelines I sent you when you were subscribed to the list, I stated a limit of 50 KB (that's kilobytes) for any message. Please remember that your message (...) (28 years ago, 9-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | IR, bitmapping
|
|
I was just wondering if you could get the handyboard to transmit other than just in 125 hz or 100hz. Also...has anyone done anything like making a robot follow another using the ir transmit? Has anyone had any success using shaft encoders to make (...) (28 years ago, 9-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: check_sensors.c
|
|
Hi Joe&David,All, Let me explain what I would like my handyboard to do. Guide a lawnmower by detecting the border of cut and uncut grass. Monitor a row of 16 +or- ir emitter/detector pairs placed about every two inches to report to the motor control (...) (28 years ago, 10-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | Sorry: Re: Inclinometer for Handyboard
|
|
I humbly apologize for the time and bandwidth I forced on everyone with my intended-to-be-small...-and-dirty sketch on the inclinometer. I honestly did not realize the size of the file when I sent it or I'd have found a much better way of doing so. (...) (28 years ago, 10-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | External ram
|
|
Hello all, I have an 68hc11F1 and 32 K of external ram and 32k of flsah. I have the 16 mhz version of the hc11. While having problems to program the flash suggestions from the list where that i probably had a timing problem. So i reduced the (...) (28 years ago, 10-Jul-98, to lugnet.robotics.handyboard)
|