To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *41194 (-5)
  Re: Motor Speed Control
 
(...) That's the case too for Swan firmware with standard parameters. (...) And yes, power consumption is much higher using on break. I measured variation of RCX current with one motor, power level 3 (50% duty cycle). Idle RCX current (35mA) is (...) (22 years ago, 1-Dec-04, to lugnet.robotics.rcx.nqc)
 
  Re: That doesn't totally seem right.
 
(...) The datalog was 27 but is now 100 (I was pushed for time earlier). (...) That's exactly what happens now. (...) I can now see that the zero's fade over time. Here's the latest results. Variable 4: 1 Variable 4: 5 Variable 4: 0 Variable 4: 4 (...) (22 years ago, 1-Dec-04, to lugnet.robotics)
 
  Re: That doesn't totally seem right.
 
(...) If you're storing this all in the datalog, you should be able to go much farther than 27 times through the loop. Try storing a couple hundred values (how big is the datalog?) Then, you should see the time-between-changes get bigger. Also, it (...) (22 years ago, 1-Dec-04, to lugnet.robotics)
 
  That doesn't totally seem right.
 
(...) That occured to me after my last posting, but I can't think why it wouldn't slow. (...) Yes, your right. I've switched to the 10x Swan firmware, and stored the results in the datalog. Here they are Variable 4: 4 Variable 4: 0 Variable 4: 3 (...) (22 years ago, 1-Dec-04, to lugnet.robotics)
 
  Re: RCX and the 9v system - help needed!
 
(...) Ah, yes, the cows! I remember them. Brilliant idea and within my realm of expertise! Thanks. Chris (22 years ago, 1-Dec-04, to lugnet.robotics, FTX)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR