To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *40984 (-5)
  Re: Help installing brickOS
 
(...) Sure. The configure script tries to find the gcc cross compiler toolchain for the brick's hitachi processor. This chain is needed to compile brickOS to a program that can be run by the RCX. But it seems that you did not install the tool chain. (...) (22 years ago, 28-Oct-04, to lugnet.robotics.rcx.legos)
 
  BricxCC 'Float' Command not working on Scout
 
While programming a Scout using BrickCC, no matter how many times I tried, I could not get the Scout to 'float' its motors. The program was as follows- task main() { OnFwd(OUT_A); Wait(50); Float(OUT_A); } After a half second the motor would brake, (...) (22 years ago, 28-Oct-04, to lugnet.robotics)
 
  Re: Help installing brickOS
 
(...) I believe that I had the exact same problem a few weeks ago, but I found that using a pre-built package takes a lot of the hassle out of installing BrickOS. The pre-built packages can be found at: (URL) hope this helps, Timothy (22 years ago, 27-Oct-04, to lugnet.robotics.rcx.legos)
 
  Help installing brickOS
 
I'm trying to install brickOS 0.2.6.10.6 on WIN NT. After unning "configure" it's busy for along time, and terminates with the message -"No Hitachi gcc compiler found. Please install compiler and try again." Any suggestions? Thanks, Jordon (22 years ago, 27-Oct-04, to lugnet.robotics.rcx.legos)
 
  GASTON
 
Hi all, 1. Finally most of the documents, building instructions, schematics and so on are available concerning our robot GASTON (URL) Ultimate Robolab is advancing well and will soon be available for beta-testing: (URL) (22 years ago, 27-Oct-04, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR