To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *40839 (-10)
  Artbots in NY this weekend
 
It's an ArtBots invasion in Harlem! The Third Annual ArtBots: The Robot Talent Show will take place on September 17, 18, & 19 from noon to 6:00pm at The Mink Building on 126th Street & Amsterdam Avenue in Harlem. Featuring the work of 20 artists and (...) (22 years ago, 16-Sep-04, to lugnet.robotics, FTX)
 
  Re: POC Exploration Robot
 
Mathieu, I guess this is not exactly you are looking for, but it can give some help. This is a prohject i made (most for functionality than design...) of a remote controled rover, with a (no lego) wireless camera. (URL) rover is based on kit 7471 (...) (22 years ago, 16-Sep-04, to lugnet.robotics)
 
  Re: RCX 2.0 Power Supply
 
(...) Sure it can be done, but it is very uncommon. I seriously doubt that any wall-wart (even very good ones) do it. I have a very high quality wall-wart. It puts out 2A at 3 to 24V, is very stable at the whole range from very little to full load (...) (22 years ago, 16-Sep-04, to lugnet.robotics, lugnet.trains)
 
  Re: RCX 2.0 Power Supply
 
(...) A friend did the mistake for me... but I had to repair a few of his RCXs! The connector he used to plug an external supply was prone to be shorted (on RCX side) when he unplugged it. It was only several fuses later that we understood the (...) (22 years ago, 16-Sep-04, to lugnet.robotics, lugnet.trains, FTX)
 
  Re: Lego Compatible (was Re: JCX and Legos...)
 
(...) (URL) All I can say is wow, and thanks. RoboBrix is a very cool line of products. Have you yet interfaced the h-bridge modules to an RCX output so that it mimics the RCX output? Also, on the shaft encoder board, do you sell any (...) (22 years ago, 16-Sep-04, to lugnet.robotics)
 
  Re: POC Exploration Robot
 
Mathieu, My replies are mixed in your message, hope they are helpful. --- Mathieu Lalonde <e0nblue@ssl-mail.com> wrote: [[snip]] (...) This is reasonable, since you are talking about two mindstorms kits, plus vision command, though you could use any (...) (22 years ago, 16-Sep-04, to lugnet.robotics)
 
  POC Exploration Robot
 
<>Hello everyone, I am student in industrial computing (the Quebec counterpart of Computer Science), and I am seriously considering using Lego Mindstorms for my final project. What my teammate and I would like to do is a proof-of-concept exploration (...) (22 years ago, 16-Sep-04, to lugnet.robotics)
 
  Re: RCX 2.0 Power Supply
 
(...) Not nearly impossible. It just requires a little more intelligence be put into the power supply. All the regulated power supplies my company produces contain a circuit called a down programmer. This circuits job is to discharge the filter (...) (22 years ago, 16-Sep-04, to lugnet.robotics, lugnet.trains)
 
  Re: RCX 2.0 Power Supply
 
(...) Thanks for pointing that out, Philo. I think I'll stick to the non-hopped up version! :-) (...) Hopefully you didn't find this out the hard way... Mark (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains, FTX)
 
  Re: RCX 2.0 Power Supply
 
(...) It is nearly impossible to build a power supply that puts out the rated voltage when there is no load. Most will put out too high a voltage (like you have seen), some just shut down. To meassure the voltage of a PS, shorten it with a 1000 Ohm (...) (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR