 | | Re: HB Memory...
|
|
This is what Fred Martin wrote in a earlier message to this mail list. This is the approximate breakdown of the HB memory space. User program object code + user global variables: 16320 bytes available Runtime pcode OS: 7936 bytes Used stack space (...) (28 years ago, 17-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | RE: Cheap air flow sensor
|
|
(...) Do you happen to know if those changes are linear? Something like this would make a cool replacement for the MAS on the Talon. It uses a series of honeycombs (that form little diamond shapes). Then it measures the number of spinning vortices (...) (28 years ago, 17-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: HB Memory...
|
|
(...) Brian, The RAM memory space is divided into two big parts very roughly like this: 0x8000 - about 0xBE00 or so = your "user" program (the C program sent by I-C) 0xBFxx - 0xBFFF = interrupt vector table (immovable!) 0xC000 - 0xFEFF = PCODE.S19 (...) (28 years ago, 17-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | hog_processor()
|
|
Could someone tell me how to use the hog_processor(). I want to dedicate the controller to only one task. I tried the following program but it did not go faster than 700HZ. void main() { while(1) { hog_processor(); v_opt = analog(0); /*measure (...) (28 years ago, 17-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Newbie
|
|
Hi all, I'm new on this board, and just ordered my handyboard. As for hardware , i still have lots of bend-sensors (strain-gages) recovered from old PowerGlove's. If anyone needs these sensors, please email me, I will use them myself on the project (...) (28 years ago, 17-Jun-98, to lugnet.robotics.handyboard)
|