Subject:
|
hog_processor()
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 17 Jun 1998 07:07:33 GMT
|
Original-From:
|
HECTOR NORIEGA <110060.2126@COMPUSERVEavoidspam.COM>
|
Viewed:
|
1155 times
|
| |
| |
Could someone tell me how to use the
hog_processor(). I want to dedicate the
controller to only one task. I tried the following
program but it did not go faster than 700HZ.
void main()
{
while(1)
{
hog_processor();
v_opt = analog(0); /*measure optical sensor */
poke(0x6fff,v_opt); /* A/D correction */
} /* end of while */
} /* end of main program*/
Thank you in advance.
Hector Noriega
Student
Long Beach State University
Electrical Engineering Dept.
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|