To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3961 (+5)
  Re: handyboard reset vector
 
Hi Justin, I believe the previous mail indicates assembly the code rather. This would be the generating the "p code" of the handy board rather than the actual IC code. Regards, -Pandit ---...--- (...) using (...) (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
 
  Re: Cheap air flow sensor
 
Elektor had published a similar circuit for detecting air leaks. The heated transistor and another transistor acting as temp. sensor were glued together using heatsink compound. You had then to nullify/calibrate a meter at ambient temp. when the (...) (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
 
  RE: Cheap air flow sensor
 
The classic small air flow sensor is a hot-wire-anemometer. Just position a short piece of very fine wire in the airflow and normal to it, run a constant current thru it, and measure the voltage change due to the cooling effect of the airflow. Works (...) (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
 
  Moder Identification Needed
 
I have a couple of nice motors that I would like to get some info on. They were removed from some medical recording devices. They are very small and have pretty good power. If you try to stop the motor by grabbing the bushing on the shaft, it is (...) (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
 
  Re: Moder Identification Needed
 
Check out (URL) - Mike (...) (28 years ago, 16-Jun-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR