 | | Re: Pad/Hole Widths
|
|
Thanks, I was going to use a pad/hole size of .050/.028. The default size of my library uses .050/.025. I checked some pin size data and it shows .015 (min) to .023 (max). Allowing .008 to .010 extra and .003 for plating, it seems that the best size (...) (29 years ago, 18-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Harddisk-Crash - HELP
|
|
Hi all, during a harddiskcrash on my computer, i lost all my handyboard mailings. I the past i had contact with view german people but i haven´t any mail-adresses. Please contact me again !!!!! Bye Bernd Klein ;-) P.S. Is there a way to get all (...) (29 years ago, 18-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Pad/Hole Widths
|
|
Hi Mike check with your board manufacturer for production specification. The via hole size I resently used was 12mil with a via size of 16mil. For Pad/Hole Width use the specifications of the parts you want to put on your board. A hole should be (...) (29 years ago, 18-May-98, to lugnet.robotics.handyboard)
|
| |
 | | RC Servo motor internal electronics
|
|
Has anyone out there ever seen, heard about, or thought about the details of electronic circuit built into a hobby servo motor to do the positioning and maintaining the position based on the signal pulse sent? I am interested in any information or (...) (29 years ago, 18-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Pad/Hole Widths
|
|
Does anyone know what typical Pad/Hole Widths are for thru-hole parts? What about via/hole widths? Is there a web site for PCB geometry sizes that someone could point me to? Thanks -- ---...--- ipscone@halcyon.com Shoot-To-Win! Protect the 2nd (...) (29 years ago, 17-May-98, to lugnet.robotics.handyboard)
|