Subject:
|
Pad/Hole Widths
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 17 May 1998 07:56:45 GMT
|
Original-From:
|
Mike Davis <ipscone@halcyon.com^avoidspam^>
|
Viewed:
|
2130 times
|
| |
|
|
Does anyone know what typical Pad/Hole Widths are for thru-hole
parts? What about via/hole widths?
Is there a web site for PCB geometry sizes that someone could point
me to?
Thanks
--
-----------------------------------------------------------------
ipscone@halcyon.com Shoot-To-Win!
Protect the 2nd Amendment! Your rights may be next!
-----------------------------------------------------------------
|
|
Message has 1 Reply:
 | | Re: Pad/Hole Widths
|
| Hi Mike check with your board manufacturer for production specification. The via hole size I resently used was 12mil with a via size of 16mil. For Pad/Hole Width use the specifications of the parts you want to put on your board. A hole should be (...) (27 years ago, 18-May-98, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
