 | | Error in UBS plotter instructions!
|
|
I just got my Ultimate builders set last week and found that the plotter model is way too cool. I built it, but the sample program didn't work the way it was supposed to. I looked at the program and it had programming for sensor ports 1 and 2. So I (...) (22 years ago, 9-Aug-03, to lugnet.robotics)
|
| |
| | Re: BrickOS installation with WinME and Cygnus problems
|
|
(...) Tom, Max, I have seen the "Permission Denied" message before. I ussually get this error message after I have done some upgrading Cygwin packages or installling new parts, etc. The best answer I have (and the one I use) is to reinstall Cygwin. (...) (22 years ago, 9-Aug-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: BrickOS installation with WinME and Cygnus problems
|
|
(...) Odd. I don't understand where that "Permission denied" message came from. What happens if you simply run "less"? Does less work on any files at all? Perhaps you would like to take this to the Cygwin mailing list (cygwin@cygwin.com). (I (...) (22 years ago, 9-Aug-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: BrickOS installation with WinME and Cygnus problems
|
|
(...) Max, Here's one of your suggestions, and the cygcheck.out file is in the email (the check is in the mail) ;) Most of this is greek to me; it's been a long time since I've been able to deal with a Unix system. Tom Pugsley ===...=== (...) (22 years ago, 9-Aug-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: BrickOS installation with WinME and Cygnus problems
|
|
(...) If you use "./configure && make", then make will only run if ./configure completes successfully. (...) ... (...) This suggests that your compiler is broken. Personally, I have never used the prebuilt compiler from Hitachi, preferring to (...) (22 years ago, 9-Aug-03, to lugnet.robotics.rcx.legos)
|
