To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *37709 (-5)
  A better full adder!
 
I realized this afternoon that I could cull a switch from my earlier design. It's now down to 12 switches from 13. 4 switches ganged onto each piston. The wiring schematic is here: (URL) on how to interpret the diagram can be found in an earlier (...) (23 years ago, 26-Jun-03, to lugnet.technic, lugnet.robotics)
 
  Re: gear pulley/release system
 
Oh wait, we can make the gear flip with the backward motion of the 1x16 blue beam right? (...) (URL) > (...) (URL) > (...) (URL) (...) (URL) you Yahoo!? SBC Yahoo! DSL - Now only $29.95 per month! (URL) (23 years ago, 25-Jun-03, to lugnet.robotics)
 
  Re: gear pulley/release system
 
Cool! How does the gear flip? Changing the motor to Float? Rich (...) (URL) (...) (URL) (...) (URL) (...) (URL) you Yahoo!? SBC Yahoo! DSL - Now only $29.95 per month! (URL) (23 years ago, 25-Jun-03, to lugnet.robotics)
 
  Re: gear pulley/release system
 
The only thing I can come up with just now is this: (URL) arrow points in the direction that the blue 1x16 brick is moved to charge. At the end of this closest to the camera there should be rubberbands. When the brick is almost back the small arm (...) (23 years ago, 25-Jun-03, to lugnet.robotics)
 
  2 Questions
 
Is it possible to reserve a particular RCX variable using NQC and then access it from within the program? And is using SetVar() the correct/best way to send a variable to the rcx using VB/spirit.ocx? I'd also like to know if their are any online (...) (23 years ago, 25-Jun-03, to lugnet.robotics.rcx)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR