To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *37624 (-5)
  version of firmware
 
Where can i see the version (1.5 or 2.0) of the firmware that is loaded into an RCX? thanks, Rich ___...___ Do you Yahoo!? SBC Yahoo! DSL - Now only $29.95 per month! (URL) (23 years ago, 16-Jun-03, to lugnet.robotics)
 
  Re: MOC - Small Pneumatic Biped Walker
 
(...) Oh my goodness! That is increadible! Wow, I just can't believe it. That must have been one tough cookie to break! May the Walker Maddness never stop! e (23 years ago, 16-Jun-03, to lugnet.technic, lugnet.robotics)
 
  RE: EGAD! (pneumatics)
 
(...) That sounds like a coil would have to stay energized, consuming power all the time. When power is removed, the state would be reset. Using a motor to move a mechanical valve control would eliminate that problem, but then feedback would be (...) (23 years ago, 16-Jun-03, to lugnet.robotics)
 
  RE: EGAD! (pneumatics)
 
If I remember right, a 555 can be used as a pulse detector. Obviously, a microcontroller is the better choice, but a 555 based circuit (if possible) would be easier to duplicate by the general population. -----Original Message----- From: Philippe (...) (23 years ago, 16-Jun-03, to lugnet.robotics)
 
  Re: OS X Complier problems solved--now struggling with BrickOS
 
(...) You know, I think there's some cosmic law. Just after hitting the send key, I'll almost always realize my question was stupid. Looking at the errors I was getting, I noticed that it was the utilities that you'd already created. firmdl3 has the (...) (23 years ago, 16-Jun-03, to lugnet.robotics.rcx.legos)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR